Review and Installation of the Vellet Under Bench Unit
Hey everyone, Wess here! Today, I'm going to walk you through the review and installation of the Vellet under bench unit. This versatile unit is available in 12V, 24V, and 48V options. For my setup, I chose the 24V unit, and I'm excited to share the process with you. Let's dive into what's inside the box and get started!
Unboxing the Vellet Under Bench Unit
Upon opening the box, the first thing you notice is the unit itself. The front features an intake that pulls air from the interior cabin space. On one side, there are two 2.5-inch holes for the ducting that will blow cool air into your living area. The rear has 6-inch ducting connections for exhaust and intake. The unit also includes a control panel on the front and an exterior remote panel for flexible installation options.
Inside the box, you'll find:
- A wiring harness ready for easy plug-and-play installation.
- A drain hose to expel condensation outside your vehicle.
- Multi-directional vents that can be rotated to direct cool air where needed.
- Insulated 6-inch ducting for efficient air transfer.
- Cardboard templates for precise cutting and installation.
Installation Process
Before starting, I pre-drilled holes for the venting, exhaust, and intake vents. This preparation made the installation smoother. My setup involves a 2011 Ford E450 ambulance conversion, with the unit installed in an exterior storage compartment but drawing air from the cabin.
- Mounting the Unit: I attached the provided rubber blocks to the unit's base, which helps keep it off the floor. Using the included straps, I secured the unit in place.
- Wiring: I ran the wire harness through a pre-drilled hole into my electrical compartment. The 24V system connects directly to the battery with the unit’s built-in fuse for safety.
- Drain Tube: The drain tube runs through a hole in the floor to expel condensation. I added sealant around the hole to prevent water ingress.
- External Control Panel: I opted to mount the external control panel inside a cabinet for easy access, connecting it to the unit via the provided harness.
- Ducting: The ducting attaches to the unit with clamps. I installed the multi-directional vents inside the cabin, allowing for flexible air distribution.
- Exhaust and Intake Vents: The 6-inch insulated ducting connects the unit to the exterior vents. Using SikaFlex 221, I sealed around the vents for a secure installation.
Testing the Unit
With everything installed, I powered up the unit using the remote control. Initially set to the highest fan speed and lowest temperature (16°C), the unit began cooling the cabin within minutes. After running for 10-15 minutes, the air inside was significantly cooler, even on a hot day. The unit pulled about 500 watts on boost mode but should run efficiently on eco mode at around 350 watts overnight.
Final Thoughts
The Vellet under bench unit exceeded my expectations with its performance and ease of installation. The instructions were clear, and the plug-and-play design made the process straightforward. If you’re in the market for a reliable cooling solution for your rig, I highly recommend checking out Vellet. You can find more information and purchase the unit at velitcamping.com
Thanks for joining me on this installation journey. See you down the road!
Purchase Velits under the bench A/C on Velit camping.
Watch the full installation video below:
